3.   Non Volatile Memory Parameters

Your Pace ISDN TA ISDN TA stores parameters in non volatile memory (E2PROM). These parameters are:

 - Configuration parameters through #parameter_id

 - Dial string used for automatic call setup (40 characters) using AT&Z command

 - Current AT registers as described below using &W command

These commands store the parameters in non-volatile memory but do not set-up Pace ISDN TA to act on them. Setting-up is done after resetting Pace ISDN TA through power down/on or AT#Z. In case of non-consistant parameter values, Pace ISDN TA is restarted using the factory configuration (allowing the user to change incorrect parametrs values).

AT&F restarts Pace ISDN TA with the factory default parameters and not the non-volatile values. The following parameters are saved using AT&W command:

 - DTE channel 1 asynchronous PAD to PAD/V.42bis parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 6 telephony parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 7 PPP async/sync parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 8 V.14 parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 10V.120/V.42bis parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 11 PAD B channel parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 12 PAD D channel parameters:

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 13 V.120/V.42bis 2 B-channel aggregation parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 14 VideoPAD B-channel parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format

 - DTE channel 15 VideoPAD D-channel parameters:

  - S0: Autoanswer or manual answer to an incoming call

  - S110, &O: Current DTE channel

  - S112: AT message format