S-Registers Summary

		S-Registers Summary

Command	Function	Range	Units	Saved	Default
S0	Rings to Auto-Answer	0-255	rings	*	0
S1	Ring Counter	0-255	rings	-	0
S2	Escape Character	0-255	ASCII	*	43
S3	Carriage Return Character	0-127	ASCII	-	13
S4	Line Feed Character	0-255	ASCII	-	10
S5	Backspace Character	0-32	ASCII	-	8
S6	Wait Time for Dial Tone	0-7	s	*	4
S7	Wait Time for Carrier	0-58	s	*	40
S8	Pause Time for Dial Delay Modifier	1-10	s	*	2
S9	Carrier Detect Response Time	0-255	0.1 s	*	6
S10	Carrier Loss Disconnect Time	0-255	0.1 s	*	14
S12	Escape Prompt Delay	0-255	0.02 s	*	50
S14	General Bit Mapped Options Status	-	-	-	138
S16	Test Mode Bit Mapped Options Status (&T)	-	-	-	0
S18	Test Timer	0-255	s	*	0
S20	AutoSync HDLC Address or BSC Sync Character	0-255	-	*	0
S21	V.24/General Bit Mapped Options Status	-	-	*	52
S22	Speaker/Results Bit Mapped Options Status	-	-	*	118
S23	General Bit Mapped Options Status	-	-	*	190
S25	Delay to DTR Off	0-255	s or 0.01 s	-	5
S26	RTS-to-CTS Delay	0-255	0.01 s	-	1
S27	General Bit-Mapped Options Status	-	-	*	9
S28	General Bit-Mapped Options Status	-	-	*	8
S29	Flash Dial Modifier Time	1-15	10 ms	-	7
S30	Disconnect Inactivity Timer	0-255	10 s	-	0
S31	General Bit-Mapped Options Status	-	-	*	202
S32	XON Character	0-255	ASCII	-	17
S33	XOFF Character	0-255	ASCII	-	19
S36	LAPM Failure Control	0-255	-	*	7
S37	Line Connection Speed	0-23	-	*	0
S38	Delay Before Forced Hangup	0-255	s	-	20
S39	Flow Control Bit Mapped Options Status	-	-	*	131
S40	General Bit-Mapped Options Status	-	-	*	232
S41	General Bit-Mapped Options Status	-	-	*	195
S46	Data Compression Control	0-255	-	*	138
S48	V.42 Negotiation Control	0-255	-	*	7
S82	LAPM Break Control	0-255	-	-	128
S86	Call Failure Reason Code	0, 4-20	-	-	0
S95	Result Code Messages Control	0-255	-	*	2
* Register value may be stored in one of two user profiles with the &W command